Do you also pour water in the inverter like this? Your small mistake will break you into pieces!

PIONEER INDIYA NEWS HARYANA: During summers, electricity consumption increases a lot, so power cuts also increase. At that time, there is only one inverter, which becomes a big support for us. If you have an inverter, then you will use water in it. But do you know that even pouring water in the inverter can put your inverter in danger.
Now you might be wondering how is this possible. Yes, it is very important for you to know how you are putting water in the inverter. You can follow the steps given below.
Which water to use?
When you add water to the inverter, remember that the water must be canned. If you use ordinary tap water or mineral water, it can cause a big danger to you. It can damage your inverter battery causing gas formation and even a big explosion.
How to fill water in inverter?
It is often seen that people do not stop charging the inverter while filling water in the battery. Pouring water while charging increases the risk of the battery bursting. The reason behind this is the hot gases coming out of the battery. Always remember to stop charging the inverter and let it cool down for 30 minutes before filling water in the battery.
Check Old Inverter Battery
Nowadays people buy cheap batteries to save money, which are not in good condition. The possibility of gas leakage from old batteries also increases significantly. If such batteries are not checked from time to time, then they can be dangerous for you. To avoid this, contact an electrician and get it repaired immediately.